Deploy the minimum configuration of plug-ins needed to create jewelry in Rhino3D.
CircleOnObject
The CircleOnObject command places a circle on the target surface.
It works with surfaces, polysurfaces, and SubD.
You can visually check the diameter of the circle and the spacing between the circles to be placed.
CommandlineOption
- Diameter : Specify or change the diameter of the circle to be placed.
- Offset : Display the outer circle of the circle to be placed.
- Move : Moves the placed circle. After completing the command, it can be moved again by using the CircleOnObject command.
- Delete : Deletes the placed circle. After completing the command, it can be deleted again by using the CircleOnObject command.
You can use the keyboard’s HotKey to check Circle’s resizing in real time.
Circle:
Q = +0.1
E = -0.1
Offset circle:
A = -0.1
D = -0.1
Right-click on a command to output it as a group.
GemCutters
The GemCutters command places Gem cutters against a circle aligned on a surface.
SubD is also supported.
Command line options allow detailed adjustments.
CommandlineOption
- TableLength : Change the height of the cutter crown.
- TableScale : Change the diameter of the cutter table.
- GirdleLength : Change the girdle height of the cutter.
- PavilionLength : Change the height of the pavilion.
- PavilionAgngle : Change the angle of the pavilion.
- BottmLength : Change the BottomLength of GemCutter.
- Position : Sets the height from the placed surface.This value determines how much the stone will sink or float from the surface.
Right-click on a command to output it as a group.
※The size of the cutter generated depends on the size of the placed circle.
ProngOnSrf
Circles for placing Prongs are lined up with the CircleOnObject command.
SubD is also supported.
Detailed adjustments can be made by command line options.
CommandlineOption
- Length : Change the length of the Prong.
- Hight : Changes the height from the surface.
- CapHight : Adjust the cap of Prong.Flat at 0.0.Round at 1.0.
Right-click on a command to output it as a group.
GemOnCircle
The GemOnCircle command lines up stones against a specified circle.
SubD is also supported.
CommandlineOption
- Height : Specifies the height of the stone from the surface.
Right-click on a command to output it as a group.
RoundGemConduit
The RoundGemConduit command is a gem creation command created using DisplayConduit.
CommandlineOption
- Diameter : Specifies the diameter of the round gem.
- Girdle : On to get the outline of the gem. Do not get outlines with Off.
GetCenterPoint
The GetCenterPoint command can be used to obtain the center points of multiple circles at once.
Even the center points of rebuilt circles can be retrieved.
